Toyota Venza: Installation

Toyota Venza Service Manual / Window / Glass / Rear Power Window Switch / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Engage the 2 claws and install the power window regulator switch assembly.

2. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR POWER WINDOW RE ...

Relay

On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RR DEF RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (a) Disconnect the D25 certification ECU (smart key ECU assembly) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the va ...

On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the curtain shield airbag assembly. PROCEDURE 1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) ...

Removal
REMOVAL PROCEDURE 1. REMOVE COOL AIR INTAKE DUCT SEAL (a) Using a clip remover, remove the 12 clips and cool air intake duct seal. 2. REMOVE RADIATOR GRILLE 3. REMOVE FRONT BUMPER ASSEMBLY ...