Toyota Venza: Installation

Toyota Venza Service Manual / Window / Glass / Power Window Regulator Motor(for Rear Door) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.

(a) Using a T25 "TORX" driver, install the rear power window regulator motor assembly with the 3 screws.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

HINT:

A new rear window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

5. INSTALL REAR DOOR GLASS RUN

6. INSTALL REAR DOOR SERVICE HOLE COVER

7. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

9. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

10. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

12. INITIALIZE POWER WINDOW CONTROL SYSTEM

(See page )

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGAT ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE POWER DISTRIBUTION (a) Remove the bolt. (b) Disengage the 2 claws and disconnect the power distribution from the relay box as shown in the illustration. (c) ...

AV Signal Stoppage (Low Battery Voltage) (B158F)
DESCRIPTION This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the navigation receiver assembly dropping temporarily. DTC No. DTC Detection Condition Trouble Area ...

Rear Sensor Communication Malfunction (C1AED)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the rear sensors and the ECU, or when there is a malfunction in a rear sensor. DTC No. DTC Detection Condition Troubl ...

Toyota Venza: Installation

Removal

Quarter Window Glass

Other materials about Toyota Venza: