INSTALLATION
PROCEDURE
1. INSTALL HEADLIGHT ASSEMBLY
(a) Connect each connector.
(b) Install the headlight assembly with the bolt and 3 screws.
Torque:
3.6 N·m {37 kgf·cm, 32 in·lbf}
2. INSTALL FRONT BUMPER ASSEMBLY
(See page )
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
4. ADJUST HEADLIGHT AIMING
(See page )
5. ADJUST FOG LIGHT AIMING
(See page )
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repair" after replacing the fuel pump assembly (See
page ).
PROCEDURE
1. DISCHARGE FUEL SYSTEM PRESSURE
(a) Discharge fuel system pressure (See page
).
2. DISCONNECT CABLE FR ...
VIN not Programmed or Mismatch - ECM / PCM (P0630)
MONITOR DESCRIPTION
DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored
in the Engine Control Module (ECM) or the input VIN is not accurate. Input the VIN
with the Techstream.
DTC No.
DTC Detection Conditi ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT NO. 1 ULTRASONIC SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified ...