Toyota Venza: Installation

Toyota Venza Service Manual / Exterior Panels / Trim / Rear Bumper / Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR BUMPER ASSEMBLY

(a) w/ Intuitive Parking Assist System:

(1) Connect each connector.

(b) Engage the 6 claws and install the rear bumper assembly as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.

(d) Install the screw.

HINT:

Use the same procedure for the RH side and LH side.

(e) Engage the 2 clips and install the 2 screws.

(f) Install the 2 bolts and 2 screws.

Torque:

Bolt :

5.5 N·m {56 kgf·cm, 49 in·lbf}

(g) Engage the 2 clips.

2. INSTALL REAR BUMPER PLATE LH

(a) Engage the 2 claws and install the rear bumper plate LH.

3. INSTALL REAR BUMPER PLATE RH

HINT:

Use the same procedure for the RH side and LH side.

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System) 2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) 3. REMOVE NO. 1 ULTRASONIC ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 1 REAR BUMPER REINFORCEMENT (a) Install the No. 1 rear bumper reinforcement with the 6 nuts. Torque: 68 N·m {693 kgf·cm, 50 ft·lbf} ...

Other materials about Toyota Venza:

Satellite Radio Broadcast cannot be Received
CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast. PROCEDURE 1 ...

If your vehicle overheats
The following may indicate that your vehicle is overheating. • The engine coolant temperature gauge reaches the maximum, or a loss of engine power is experienced. (For example, the vehicle speed does not increase.) • Steam comes out from under the hood ...

Installation
INSTALLATION PROCEDURE 1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY (a) Coat a new O-ring with ATF and install it to the ATF temperature sensor assembly. Text in Illustration *1 O-ring ...