Toyota Venza: Installation
INSTALLATION
PROCEDURE
1. REPAIR INSTRUCTION
.gif)
2. INSTALL REAR DOOR LOWER OUTSIDE STRIPE
(a) Refer to the illustration to position the rear door lower outside stripe.
Standard Measurement
|
Dimension |
Measurement |
|---|---|
|
A |
+1.5 mm (+0.0591 in.) |
|
B |
-1.0 mm (-0.0394 in.) |
|
C |
7.5 mm (0.295 in.) |
(b) Remove the release paper and apply the stripe.
3. INSTALL NO. 2 BLACK OUT TAPE
(a) Refer to the illustration to position the No. 2 black out tape.
Standard Measurement
|
Dimension |
Measurement |
|---|---|
|
A |
+1.5 mm (+0.0591 in.) |
|
B |
-1.0 mm (-0.0394 in.) |
|
C |
5.0 mm (0.197 in.) |
(b) Remove the release paper and apply the tape.
4. INSTALL REAR DOOR OUTSIDE STRIPE
(a) Refer to the illustration to position the rear door outside stripe.
Standard Measurement
|
Dimension |
Measurement |
|---|---|
|
A |
+1.5 mm (+0.0591 in.) |
|
B |
-1.0 mm (-0.0394 in.) |
(b) Remove the release paper and apply the stripe.
5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY
6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
7. INSTALL REAR DOOR GLASS RUN
8. INSTALL REAR DOOR WEATHERSTRIP
9. INSTALL REAR DOOR CHECK ASSEMBLY
10. INSTALL REAR DOOR SERVICE HOLE COVER
11. INSTALL REAR DOOR FRAME GARNISH
12. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
13. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
14. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
15. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
17. INITIALIZE POWER WINDOW CONTROL SYSTEM
(See page )
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
2. RE ...
Front Bumper
...
Other materials about Toyota Venza:
Cruise control
Use the cruise control to maintain a set speed without depressing the accelerator
pedal.
1. Indicators
2. Cruise control switch
- Set the vehicle speed
Press the “ON-OFF” button to activate the cruise control.
Cruise control indicator will ...
Low Power Supply Voltage (C1241/94)
DESCRIPTION
If a malfunction in the power source circuit occurs, or a malfunction in communication
with the skid control ECU or in a speed sensor occurs, the AWD control ECU will
prohibit operations by the fail-safe function.
DTC No.
...
Windshield Deicer does not Operate
DESCRIPTION
When the rear window defogger switch on the air conditioning control assembly
is pressed, the operation signal is transmitted to the air conditioning amplifier
assembly through the LIN communication line. When the air conditioning amplifier
...
0.1426