Toyota Venza: Installation

Toyota Venza Service Manual / Front Suspension / Front Stabilizer Bar(when Using The Engine Support Bridge For Awd) / Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING

(a) Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

Text in Illustration

*1	Cutout
*2	Front of the Vehicle
*3	Inside of the Vehicle

NOTICE:

When installing the front No. 1 stabilizer bar bushings, make sure that the cutout faces the rear of the vehicle.

2. INSTALL FRONT NO. 2 STABILIZER BRACKET LH

(a) Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

3. INSTALL FRONT NO. 2 STABILIZER BRACKET RH

HINT:

Perform the same procedure as for the LH side.

4. INSTALL FRONT NO. 1 STABILIZER BRACKET LH

(a) Install the front No. 1 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

5. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:

Perform the same procedure as for the LH side.

6. TEMPORARILY INSTALL FRONT STABILIZER BAR

(a) Temporarily Install the front stabilizer bar to the vehicle.

NOTICE:

Use wire or an equivalent tool to keep the front stabilizer bar.

7. TEMPORARILY INSTALL STEERING LINK ASSEMBLY

8. INSTALL FRONT FRAME ASSEMBLY

for 1AR-FE: (See page )

for 2GR-FE: (See page )

9. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

(a) Install the front stabilizer link assembly LH with the 2 nuts.

Torque:

Nut A :

130 N·m {1326 kgf·cm, 96 ft·lbf}

Nut B :

74 N·m {755 kgf·cm, 55 ft·lbf}

HINT:

If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

10. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.

11. INSTALL FRONT WHEELS

12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(See page )

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT STABILIZER LINK ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the front stabilizer link assembly in a vise using aluminum ...

Front Stabilizer Bar(for 1ar-fe 2wd)

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT FRONT STABILIZER LINK ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the ...

Other materials about Toyota Venza:

ECM / PCM Processor (P0606)
MONITOR DESCRIPTION The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM illuminates the MIL and stores the DTC imm ...

Cruise control
Use the cruise control to maintain a set speed without depressing the accelerator pedal. 1. Indicators 2. Cruise control switch - Set the vehicle speed Press the “ON-OFF” button to activate the cruise control. Cruise control indicator will ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Power Steering System DTC Code ...