Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

CAUTION / NOTICE / HINT

NOTICE:

  • Do not replace the spiral cable with the battery connected and the ignition switch ON.
  • Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.
  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE

1. INSTALL STEERING SHAKE DAMPER

(a) Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.

Torque:

2.4 N·m {24 kgf·cm, 21 in·lbf}

2. INSTALL CRUISE CONTROL SWITCH WIRE

3. INSTALL CRUISE CONTROL MAIN SWITCH


4. INSTALL STEERING PAD SWITCH ASSEMBLY

(a) Engage the 2 claws, 2 pins and 2 guides to install the steering pad switch assembly.

(b) Install the 2 screws.

Torque:

2.4 N·m {24 kgf·cm, 21 in·lbf}

(c) Pass the wire harness over the 2 guides.


5. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

6. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


7. INSTALL STEERING WHEEL ASSEMBLY

(a) Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.

Text in Illustration

*1

Matchmark


(b) Install the steering wheel assembly set nut.

Torque:

50 N·m {510 kgf·cm, 37 ft·lbf}

(c) Connect each connector to the spiral cable sub-assembly.

8. INSPECT STEERING WHEEL CENTER POINT

9. INSTALL STEERING PAD

(See page )


Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: Do not replace the spiral cable with the battery connected and the ignition switch ON. Do not rotate the spiral cable without the steering wh ...

Steering Gear / Linkage
...

Other materials about Toyota Venza:

Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT HINT: It is possible that a bulb is incorrectly installed, affecting headlight aim. Bulb installation should be considered prior to performing the adjustment procedure. PROCEDURE 1. PREPARE VEHICLE FOR HEADLIGHT AIM AD ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT LOWER SUSPENSION ARM (a) Install the front lower arm bushing stopper t ...

Check CAN Bus Lines for Short Circuit
DESCRIPTION There may be a short circuit in the CAN bus main wire and/or CAN branch wire when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is below 54 Ω. Symptom Trouble Area Resistance betwe ...

© 2016-2024 Copyright www.tovenza.com

0.1207