Toyota Venza: Installation

Toyota Venza Service Manual / 1ar-fe Starting / Engine Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL ENGINE SWITCH

(a) Attach the 2 claws to install the engine switch.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

(a) Connect the connector.

(b) Engage the 4 claws to install the lower instrument panel finish panel assembly.

3. INSTALL INSTRUMENT CLUSTER FINISH PANEL

4. INSTALL UPPER STEERING COLUMN COVER

5. INSTALL LOWER STEERING COLUMN COVER

6. INSTALL CONSOLE BOX SUB-ASSEMBLY

7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

8. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

11. INSTALL FRONT DOOR SCUFF PLATE RH

12. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

13. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

14. INSTALL FRONT DOOR SCUFF PLATE LH

15. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

16. INSTALL CONSOLE BOX ASSEMBLY

17. INSTALL NO. 2 CONSOLE BOX CARPET

18. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

19. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Ignition Switch

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE LOWER STEERING COLUMN COVER 2. REMOVE UPPER STEERING COLUMN COVER 3. REMOVE IGNITION SWITCH (a) R ...

Other materials about Toyota Venza:

Replacing a flat tire
Chock the tires. Slightly loosen the wheel nuts (one turn). Turn the tire jack portion “A” by hand until the notch of the jack is in contact with the jack point. Raise the vehicle until the tire is slightly raised off the ground. Remove a ...

Sound of Portable Player cannot be Heard from Speakers or Sound is Low
PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that mute is off. (b) Check that the sound of the portable player can be h ...

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: When disconnecting the steering intermediate shaft assembly and pinion shaft of steering gear assembly, be sure to place matchmarks before servicing. PROCEDURE 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. SECUR ...