Toyota Venza: Installation
INSTALLATION
PROCEDURE
1. INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
|
(a) Install the vacuum switching valve assembly (for ACIS) with the bolt. Torque: 9.0 N·m {92 kgf·cm, 80 in·lbf} |
|
.png)
(b) Connect the 2 vacuum hoses, clamp and connector.
2. INSTALL OUTER COWL TOP PANEL
.gif)
3. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
5. INSTALL FRONT FENDER TO COWL SIDE SEAL LH
6. INSTALL FRONT FENDER TO COWL SIDE SEAL RH
7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH
8. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
9. INSTALL FRONT WIPER ARM HEAD CAP
10. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WIPER ARM HEAD CAP
2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
4. REMOVE FRONT FENDER TO COWL SIDE S ...
Other materials about Toyota Venza:
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2A, 2C and 2F main body ECU (driver side junction block assembly)
connectors.
(b) Measure the voltage and resistance according to the value(s) in the table ...
System Description
SYSTEM DESCRIPTION
1. GENERAL
(a) The air conditioning system has the following controls.
Control
Outline
Neural Network Control
This control is capable of performing complex control by artificially
simu ...
Brake Switch "B" Circuit High (P0724)
DESCRIPTION
The purpose of this circuit is to prevent the engine from stalling when the brakes
are suddenly applied while driving in the lock-up condition.
When the brake pedal is depressed, this switch sends a signal to the TCM. Then
the TCM cancels the ...
0.1241