INSTALLATION
PROCEDURE
1. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
(a) Install a new fuel suction tube set gasket onto the fuel tank.
(b) Connect the fuel tube with the clip. |
|
(c) Set the fuel suction tube assembly to the fuel tank.
NOTICE:
(d) Align the protrusion of the fuel suction tube assembly with pump and gauge and the cutout of the fuel tank vent tube set plate. |
|
(e) While holding the fuel suction with pump and gauge tube assembly by hand, install the fuel tank vent tube to the fuel tank with the 8 bolts.
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
(f) Install the fuel tank main tube sub-assembly and the tube joint clip.
NOTICE:
(g) Connect the fuel pump connector. |
|
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
3. INSPECT FOR FUEL LEAK
4. INSTALL REAR FLOOR SERVICE HOLE COVER
(a) Install the rear floor service hole cover with new butyl tape. |
|
(b) Install the rear floor carpet and the rear floor silencer.
5. INSTALL REAR SEAT ASSEMBLY LH
(a) Install the rear seat assembly LH (See page ).
6. INSTALL REAR SEAT ASSEMBLY RH
(a) Install the rear seat assembly RH (See page ).
System Diagram
SYSTEM DIAGRAM
Transmitting ECU
(Transmitter)
Receiving ECU
Signal
Communication Method
Center Airbag Sensor Assembly
ECM
Crash detection signal
CAN
...
Open or Short Circuit in ABS Motor Relay Circuit (C0273/13)
DESCRIPTION
The ABS motor relay supplies power to the ABS pump motor. While the ABS is activated,
the ECU turns the motor relay on and operates the ABS pump motor.
If the voltage supplied to the motor relay (+BM) is below the DTCs detection
threshold due ...
Front Passenger Side Door ECU Communication Stop (B2322)
DESCRIPTION
This DTC is stored when LIN communication between the power window regulator
motor assembly (for front passenger side) and main body ECU (driver side junction
block assembly) stops for more than 10 seconds.
DTC No.
DTC D ...