Toyota Venza: Installation

Toyota Venza Service Manual / 1ar-fe Engine Mechanical / Rear Crankshaft Oil Seal / Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR ENGINE OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

NOTICE:

Do not allow foreign matter to contact the lip of the oil seal.
Do not allow MP grease to contact the dust seal.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

SST: 09223-15030

SST: 09950-70010

09951-07150

NOTICE:

Keep the lip of the oil seal free from foreign matter.
Do not tap in the oil seal at an angle.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

(a) Using SST, hold the crankshaft.

SST: 09213-54015

SST: 09330-00021

HINT:

Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

(b) Clean the bolts and their installation holes.

HINT:

Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

(d) Install the drive plate and rear drive plate spacer to the crankshaft.

(e) Apply a few drops of adhesive to 2 or 3 threads of the bolt end.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(f) Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.

Torque:

98 N·m {999 kgf·cm, 72 ft·lbf}

NOTICE:

Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.

3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)

When Not Using the Engine Support Bridge: (See page )

When Using the Engine Support Bridge: (See page )

4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)

When Not Using the Engine Support Bridge: (See page )

When Using the Engine Support Bridge: (See page )

Removal

REMOVAL PROCEDURE 1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD) When Not Using the Engine Support Bridge: (See page ) When Using the Engine Support Bridge: (See page ) 2. REMOVE AUTOMATIC ...

Other materials about Toyota Venza:

Head restraints
Head restraints are provided for all seats. ► Front and rear outboard seats Vertical adjustment 1. Up Pull the head restraint up. 2. Down Push the head restraints down while pressing the lock release button. ► Rear center seat (fabric seat) ...

Wireless Door Lock Buzzer
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL WIRELESS DOOR LOCK BUZZER (a) Engage the clamp and install the wireless door lock buzzer. (b) Connect the ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Toyota Venza: Installation

Removal

1ar-fe Fuel

Other materials about Toyota Venza: