INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repair" after replacing the engine assembly (See page ).
PROCEDURE
1. INSTALL IGNITION COIL ASSEMBLY
2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
3. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
4. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
5. INSTALL KNOCK CONTROL SENSOR
6. INSTALL SENSOR WIRE
(a) Install the sensor wire with the bolt. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} |
|
(b) Connect the knock control sensor connector.
7. INSTALL INTAKE MANIFOLD
8. CONNECT NO. 2 VENTILATION HOSE
9. INSTALL WATER BY-PASS HOSE
(a) Install the No. 1 and No. 2 water by-pass hoses. |
|
10. INSTALL THROTTLE BODY ASSEMBLY
11. INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET
(a) Install the bracket with the 4 bolts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} |
|
12. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
13. INSTALL NO. 2 MANIFOLD STAY
14. INSTALL MANIFOLD STAY
15. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
16. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
(a) Apply a light coat of engine oil to a new O-ring. |
|
(b) Install the O-ring to the engine oil level dipstick guide.
(c) Install the engine oil level dipstick guide with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(d) Install the engine oil level dipstick.
Power Back Door cannot be Opened or Closed Using the Power Back Door Switch
DESCRIPTION
When the power back door cannot be opened or closed using the power back door
control switch, one of the following may be malfunctioning: 1) power back door control
switch circuit, 2) power back door ECU (power back door motor unit) or 3) main ...
Fuel pump shut off system
To minimize the risk of fuel leakage when the engine stalls or an airbag inflates
upon collision, the fuel pump shut off system stops supplying fuel to the engine.
Follow the procedure below to restart the engine after the system is activated.
►Vehic ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT STABILIZER LINK ASSEMBLY
(a) Inspect the turning torque of the ball joint.
(1) Secure the front stabilizer link assembly in a vise using aluminum
plates.
(2) Install the nut to the front stabilizer ...