Toyota Venza manuals

Toyota Venza: Inspection

INSPECTION

PROCEDURE

1. INSPECT THERMOSTAT

HINT:

The valve opening temperature is inscribed on the thermostat.


(a) Immerse the thermostat in water, and then gradually heat the water.


(b) Check that the valve of the thermostat opens at the specified temperature.

Standard valve opening temperature:

80 to 84°C (176 to 183°F)

If the valve does not open as specified, replace the thermostat.

(c) Check the valve lift.

Standard valve lift:

10 mm (0.394 in.) or more at 95°C (203°F)

If the valve lift is not as specified, replace the thermostat.


(d) Check that the valve is fully closed when the thermostat is at a low temperature (below 77°C (171°F)).

If the valve is not fully closed, replace the thermostat.

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Installation
INSTALLATION PROCEDURE 1. INSTALL THERMOSTAT (a) Install a new gasket to the thermostat. (b) Install the thermostat with the jiggle valve facing upward. HINT: The jiggle valve may ...

Other materials about Toyota Venza:

Parking Brake Switch Circuit
DESCRIPTION This circuit is from the parking brake switch assembly to the radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK BRAKE WARNING LIGHT (a) Check that the brake warning light comes on when t ...

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTCS (a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG). (d) Turn the Techstream on. (e) Check for DTCs. Enter the following menus: Body Electrical / Smart Key / Trouble ...

© 2016-2024 Copyright www.tovenza.com

0.1723