INSPECTION
PROCEDURE
1. INSPECT BRAKE DISC INSIDE DIAMETER
(a) Using a brake drum gauge or an equivalent tool, measure the inside diameter of the disc. Standard inside diameter of a new disc: 190 mm (7.48 in.) Maximum inside diameter: 191 mm (7.52 in.) If the inside diameter is more than the maximum, replace the rear disc. |
|
2. INSPECT PARKING BRAKE SHOE LINING THICKNESS
(a) Using a ruler, measure the thickness of the parking brake shoe lining. Standard thickness: 2.45 mm (0.0965 in.) Minimum thickness: 1.0 mm (0.0394 in.) If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe assembly. NOTICE: Always replace both the right and left parking brake shoes together. |
|
3. INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT
(a) Apply chalk to the inside surface of the disc, then grind down the brake shoe lining to fit the disc. If the contact between the disc and the brake shoe lining is incorrect, repair it using a brake shoe grinder or replace the parking brake shoe assembly. NOTICE: Always replace both the right and left parking brake shoes together. |
|
Key-off Operation Function Operates even if Operating Conditions are not Satisfied
DESCRIPTION
When the front doors are closed, each power window regulator motor assembly
can control its power window operation for approximately 45 seconds after
the ignition switch is turned from ON to off by receiving operation permission
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL GENERATOR ASSEMBLY
(a) Install the generator with the 2 bolts.
Torque:
52 N·m {530 kgf·cm, 38 ft·lbf}
(b) Install the wire harness clamp bracke ...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Procedure
Back Door Closer System
...