Toyota Venza: Inspection

Toyota Venza Service Manual / Park Assist / Monitoring / Ultrasonic Sensor(for Rear Side) / Inspection

INSPECTION

PROCEDURE

1. INSPECT NO. 1 ULTRASONIC SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 (BI) - 5 (EI)	Always	10 kΩ or higher
1 (BI) - 2 (BO)	Always	10 kΩ or higher
3 (SI) - 4 (SO)	Always	Below 1 Ω
5 (EI) - 6 (EO)	Always	Below 1 Ω

Text in Illustration

*a	Component without harness connected (No. 1 Ultrasonic Sensor)

If the result is not as specified, replace the No. 1 ultrasonic sensor.

Removal

REMOVAL PROCEDURE 1. REMOVE REAR BUMPER ASSEMBLY (See page ) 2. REMOVE ULTRASONIC SENSOR CLIP (a) Disconnect the connector. Text in Illustration *A ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL MULTIPLEX NETWORK DOOR ECU (a) Connect the connector and install the multiplex network door ECU. (b) Install the flat cable connector as shown in the illus ...

Terminals Of Ecu
TERMINALS OF ECU 1. STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition D17-1 (GND) - Body ground ...

Lost Communication with AFS LIN (B124D)
DESCRIPTION Refer to DTC B124D (Lighting system) (See page ). DTC No. DTC Detection Condition Trouble Area B124D Malfunctions in LIN communication system Inner rear view mir ...

Toyota Venza: Inspection

Components

Removal

Other materials about Toyota Venza: