Toyota Venza: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT CUSHION HEATER LH
|
(a) Check the seat cushion heater. (1) Apply battery voltage and check the seat cushion heater. OK:
If the result is not as specified, replace the seat cushion heater. NOTICE: Immediately after confirming that the seat heater is functioning normally, remove the battery leads. Failing to do so may cause the seat heater to overheat. |
|
(b) Check the thermostat.
(1) Apply battery voltage and check the seat cushion heater.
OK:
|
Measurement Condition |
Condition |
Specified Condition |
|---|---|---|
|
Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 6 |
Always |
Seat cushion heater temperature below 55°C (129°F) |
If the result is not as specified, replace the seat cushion heater.
NOTICE:
Immediately after confirming that the seat heater is functioning normally, remove the battery leads. Failing to do so may cause the seat heater to overheat.
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT SEAT HEADREST ASSEMBLY
2. REMOVE FRONT SEAT REAR OUTER TRACK COVER
3. REMOVE FRONT SEAT REAR INNER TRACK COVER
4. REMOVE FRONT SEAT ASSEMBLY
5. REMOVE ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
(a) Using a tacker, install the separate type front seat cushion heater
to the end of the separate type front ...
Other materials about Toyota Venza:
Glossary of tire terminology
...
Customize Parameters
CUSTOMIZE PARAMETERS
HINT:
The following items can be customized.
NOTICE:
After confirming whether the items requested by the customer are applicable
or not for customization, perform customizing operations.
Be sure to record the current se ...
Engine Coolant Temperature / Intake Air Temperature Correlation (P011B)
DESCRIPTION
The engine has two temperature sensors, an engine coolant temperature sensor
and an intake air temperature sensor, to detect the temperature while the engine
is in operation. A thermistor, whose resistance value varies according to the tempera ...
0.1618