Toyota Venza: Inspection

Toyota Venza Service Manual / Heating / Air Conditioning / Front Evaporator Temperature Sensor / Inspection

INSPECTION

PROCEDURE

1. INSPECT EVAPORATOR TEMPERATURE SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	-10°C (14°F)	7.30 to 9.10 kΩ
1 - 2	-5°C (23°F)	5.65 to 6.95 kΩ
1 - 2	0°C (32°F)	4.40 to 5.35 kΩ
1 - 2	5°C (41°F)	3.40 to 4.15 kΩ
1 - 2	10°C (50°F)	2.70 to 3.25 kΩ
1 - 2	15°C (59°F)	2.14 to 2.58 kΩ
1 - 2	20°C (68°F)	1.71 to 2.05 kΩ
1 - 2	25°C (77°F)	1.38 to 1.64 kΩ
1 - 2	30°C (86°F)	1.11 to 1.32 kΩ

NOTICE:

Hold the sensor only by its connector. Touching the sensor may change the resistance value.
When measuring, the sensor temperature must be the same as the ambient temperature.

HINT:

As the temperature increases, the resistance decreases (see the graph).

If the resistance is not as specified, replace the evaporator temperature sensor.

Text in Illustration

Component without harness connected

(Evaporator Temperature Sensor)

Sensing Portion

Removal

REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING UNIT ASSEMBLY (See page ) 2. REMOVE NO. 1 FINISH PANEL MOUNTING BRACKET 3. REMOVE NO. 2 FINISH PANEL MOUNTING BRACKET 4. REMOVE NO. 3 AIR DUCT ...

Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 1 COOLER THERMISTOR (a) Install the No. 1 cooler thermistor as shown in the illustration. Part Length ...

Other materials about Toyota Venza:

System Description
SYSTEM DESCRIPTION CAUTION: If using a pacemaker, be sure to read the manual of the pacemaker before using the key, as the radio waves of the key may affect the pacemaker. 1. SMART KEY SYSTEM DESCRIPTION (a) In addition to conventional mechanical key and ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR SEAT LEG ASSEMBLY RH (a) Using a T55 "TORX" socket wrench, install the rear seat leg assembly RH with the 5 "TORX" bolts. Torque: A : 42 N·m {428 kgf·cm, 31 ft·lbf} B : ...

Blind Spot Mirrors
The Blind Spot Mirrors increase the view of surrounding area to assist the driver when checking surrounding area before changing lanes. 1. Blind Spot Mirror field of view 2. Main mirror field of view - Mirror angle can be adjusted when ►V ...