Toyota Venza: Inspection

Toyota Venza Service Manual / Heating / Air Conditioning / Compressor(for 2gr-fe) / Inspection

INSPECTION

PROCEDURE

1. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	20°C (68°F)	160 to 320 Ω

If the resistance is not as specified, replace the compressor and magnetic clutch.

Text in Illustration

*1	Component without harness connected (A/C Compressor)

2. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C COMPRESSOR SOLENOID)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
2 - 1	20°C (68°F)	10 to 11 Ω

If the resistance is not as specified, replace the compressor and magnetic clutch.

Text in Illustration

*1	Component without harness connected (A/C Compressor (Compressor Solenoid))

3. INSPECT COMPRESSOR AND MAGNETIC CLUTCH

(a) Disconnect the connector from the compressor and magnetic clutch.

(b) Disconnect the connector from the magnetic clutch.

Standard Resistance:

Tester Connection	Condition	Specified Condition
A-3 - B-1	Always	Below 1 Ω
A-3 - Body ground	Always	10 kΩ or higher

If the resistance is not as specified, replace the compressor and magnetic clutch.

Text in Illustration

Component without harness connected

(A/C Compressor)

Front view of wire harness connector

(to Magnetic Clutch)

4. INSPECT MAGNETIC CLUTCH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - Body ground	20°C (68°F)	3.8 to 4.2 Ω

If the resistance is not as specified, replace the magnetic clutch.

(b) When connector terminal 1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.

OK:

The magnetic clutch's operating sound can be heard.

The magnetic clutch's hub and rotor lock.

If the result is not as specified, replace the magnetic clutch.

Text in Illustration

*1	Component without harness connected (Magnetic Clutch)

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE MAGNETIC CLUTCH ASSEMBLY (a) Place the compressor and magnetic clutch in a vise. (b) Using SST, hold the m ...

Installation

INSTALLATION PROCEDURE 1. TEMPORARILY TIGHTEN COMPRESSOR AND MAGNETIC CLUTCH (a) Temporarily install the compressor and magnetic clutch and bracket with the 4 bolts. ...

Other materials about Toyota Venza:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the following "See page". Back Door Closer System DTC Code ...

Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure that there are no obstructions between the portable player and the radio and display receiver assembly that may block ...

Chassis
General Maintenance GENERAL MAINTENANCE PROCEDURE 1. INSPECT STEERING LINKAGE AND GEAR HOUSING (a) Check the steering wheel free play (See page ). (b) Check the steering linkage for looseness or damage. (1) Check that the tie rod ends do not have any ...