Toyota Venza: Inspection

Toyota Venza Service Manual / Heating / Air Conditioning / Compressor(for 1ar-fe) / Inspection

INSPECTION

PROCEDURE

1. INSPECT COMPRESSOR WITH PULLEY (SOLENOID VALVE)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
2 - 1	20°C (68°F)	10 to 11 Ω

If the resistance is not as specified, replace the A/C compressor (compressor with pulley).

Text in Illustration

*1	Component without harness connected (A/C Compressor (Solenoid Valve))

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COMPRESSOR FOR METALLIC SOUND (a) Check if there is abnormal metallic sound from the A/C compressor (compressor with pulley) when the A/C switch is on a ...

Removal

REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL AIR OUTLET CONTROL SERVO MOTOR SUB-ASSEMBLY (a) Check that the slots, links and gears of the air outlet control servo motor sub-assembly are positioned in the correct orientation as shown in the illustratio ...

Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING PAD SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition ...

Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier
DESCRIPTION The navigation receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit. The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers. ...