INSPECTION
PROCEDURE
1. INSPECT TIRES
(a) Inspect the tires for wear and proper inflation pressure.
Cold Tire Inflation Pressure:
Tire Size |
Front kPa (kgf/cm2, psi) |
Rear kPa (kgf/cm2, psi) |
---|---|---|
P245/55R19 103S P245/50R20 102H |
220 (2.2, 32) |
220 (2.2, 32) |
(b) Using a dial indicator, inspect the runout of the tires. Maximum Tire Runout: 1.4 mm (0.0551 in.) |
|
2. ROTATE TIRES
(a) Rotate the tires as shown in the illustration.
Text in Illustration
Front |
Torque:
103 N·m {1050 kgf·cm, 76 ft·lbf}
3. INSPECT WHEEL BALANCE
(a) Check and adjust the off-the-car balance. Maximum Wheel Imbalance After Adjustment: 8.0 g (0.0176 lb) NOTICE:
HINT: Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side. |
|
4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Inspect the front axle hub bearing looseness (See page ).
5. INSPECT REAR AXLE HUB BEARING LOOSENESS (for 2WD)
(a) Inspect the rear axle hub bearing looseness (See page ).
6. INSPECT REAR AXLE HUB BEARING LOOSENESS (for AWD)
(a) Inspect the rear axle hub bearing looseness (See page ).
7. INSPECT FRONT AXLE HUB RUNOUT
(a) Inspect the front axle hub runout (See page ).
8. INSPECT REAR AXLE HUB RUNOUT (for 2WD)
(a) Inspect the rear axle hub runout (See page ).
9. INSPECT REAR AXLE HUB RUNOUT (for AWD)
(a) Inspect the rear axle hub runout (See page ).
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2A and 2F main body ECU (driver side junction block assembly)
connectors.
(b) Measure the voltage and resistance according to the value(s) in the table
be ...
Panel Switches do not Function
PROCEDURE
1.
CHECK PANEL SWITCH
(a) Check for foreign matter around the switches that might prevent operation.
OK:
No foreign matter is found.
NG
REMOVE ANY FOREIGN MATTER FOUND
...
Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
DESCRIPTION
The Automatic Transmission Fluid (ATF) temperature sensor converts the fluid
temperature into a resistance value for use by the TCM.
The TCM applies a voltage to the temperature sensor through terminal THO1 of
the TCM.
The sensor resistanc ...