Toyota Venza: Inspection

Toyota Venza Service Manual / Front Suspension / Front Shock Absorber / Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY

(a) Compress and extend the shock absorber rod 4 or more times.

Standard:

There is no abnormal resistance or sound and operation resistance is normal.

HINT:

If there is any abnormality, replace the front shock absorber with a new one.

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT WHEE ...

Disposal

DISPOSAL PROCEDURE 1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY (a) Position the front shock absorber assembly level with the piston rod fully extended. Using a drill, make a hole in ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY (a) Align the matchmarks on the steering intermediate shaft assembly and the steering column assembly. Text in Illustration *1 Matc ...

Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a known good one and check that the malfunction disappears. OK: Malfunction disappears. OK END NG REPLACE RADIO AN ...

Road Test
ROAD TEST 1. PROBLEM SYMPTOM CONFIRMATION (a) Inspect the SET function. Text in Illustration *1 ON/OFF *2 - SET (1) Turn the cruise control main switch on. (2) Drive at the required speed of bet ...