Toyota Venza: Inspection

Toyota Venza Service Manual / Steering Gear / Linkage / Steering Gear(for 1ar-fe 2wd) / Inspection

INSPECTION

PROCEDURE

1. INSPECT TIE ROD ASSEMBLY LH

2. INSPECT TIE ROD ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.

3. INSPECT TOTAL PRELOAD

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE STEERING RACK BOOT CLIP (for LH Side) (a) Using pliers, remove the steering rack boot clip. 2. REMOVE STEERING RACK BOOT CLIP (for RH Side) HINT: Perform the same ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. ...

Other materials about Toyota Venza:

Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle. - Correct use of the seat belts 1. Extend the shoulder belt so that it comes fully over the shoulder, but does not come into contact with the neck or slide off ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Rear View Monitor System DTC Code Detection Item See page C1622 Back Camera Disconnected ...

Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page ). NOTICE: Be sure to read "Precaution" thorou ...