Toyota Venza: Inspection

Toyota Venza Service Manual / 1ar-fe Starting / Engine Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT ENGINE SWITCH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
7 (SS1) - 5 (GND)	Not pushed	10 kΩ or higher
2 (SS2) - 5 (GND)	Not pushed	10 kΩ or higher
7 (SS1) - 5 (GND)	Pushed	15 Ω
2 (SS2) - 5 (GND)	Pushed	15 Ω

If the result is not as specified, replace the engine switch.

(b) Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.

HINT:

If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the engine switch indicator light will not illuminate.
If the voltage is too low, the indicator light will not illuminate.

OK:

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 11 (SWIL) Battery negative (-) → Terminal 4 (COM) or 5 (GND)	Illuminates
Battery positive (+) → Terminal 12 (INDS) Battery negative (-) → Terminal 4 (COM) or 5 (GND)	Illuminates
Battery positive (+) → Terminal 13 (INDW) Battery negative (-) → Terminal 4 (COM) or 5 (GND)	Illuminates

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 11 (SWIL)

Battery negative (-) → Terminal 4 (COM) or 5 (GND)

Illuminates

Battery positive (+) → Terminal 12 (INDS)

Battery negative (-) → Terminal 4 (COM) or 5 (GND)

Illuminates

Battery positive (+) → Terminal 13 (INDW)

Battery negative (-) → Terminal 4 (COM) or 5 (GND)

Illuminates

Text in Illustration

*1	Indicator Light

If the result is not as specified, replace the engine switch.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Other materials about Toyota Venza:

Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch
DESCRIPTION If the manual up/down function can be performed but the auto up/down function cannot, then the fail-safe mode may be functioning. If the power window initialization (See page ) has not been performed, the auto up/down function will not oper ...

Dtc Check / Clear
DTC CHECK / CLEAR NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame ...

Television Camera
Components COMPONENTS ILLUSTRATION ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY 2. REMOVE REAR WIPER ARM HEAD CAP 3. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY 4. REMOVE REAR WIPER MOTOR GROMMET 5. ...