DESCRIPTION
This circuit detects the state of the ignition switch, and sends it to the inner rear view mirror assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (BATTERY - INNER REAR VIEW MIRROR ASSEMBLY) |
(a) Disconnect the P12 inner rear view mirror assembly connector. |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
P12-1 (IG) - Body ground |
Ignition switch ON |
11 to 14 V |
Ignition switch off |
Below 1 V |
*1 |
Front view of wire harness connector (to Inner Rear View Mirror Assembly) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
2. |
CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BODY GROUND) |
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
System Voltage (P0560)
DESCRIPTION
The battery supplies electricity to the ECM even when the ignition switch is
off. This power allows the ECM to store data such as DTC history, freeze frame data
and fuel trim values. If the battery voltage falls below a minimum level, the stor ...
Evaporative Emission Control System Incorrect Purge Flow (P0441)
DTC SUMMARY
DTC No.
Monitoring Item
Malfunction Detection Condition
Trouble Area
Detection Timing
Detection Logic
P0441
Purge VSV (Vacuum Switching Valve) stuck open ...
Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound signal from an external
device to the navigation receiver assembly via this circuit.
The sound signal that has been sent is amplified by the navigation receiver assembly
and then is sent ...