Toyota Venza: Initialization has not been Performed (B2450)

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Initialization has not been Performed (B2450)

DESCRIPTION

The headlight leveling ECU assembly stores this DTC if initialization has not been performed after the ECU was replaced.

DTC No.	DTC Detecting Condition	Trouble Area
B2450	Initialization of the headlight leveling ECU assembly has not been performed	Headlight leveling ECU assembly

PROCEDURE

1.	PERFORM INITIALIZATION

(a) Perform initialization of the headlight leveling ECU assembly (See page ).

2.	RECHECK FOR DTC

(a) Using the Techstream, recheck for DTCs.

Result	Proceed to
DTC B2450 is not output.	A
DTC B2450 is output.	B

HINT:

If the headlight leveling ECU assembly stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the headlight leveling ECU assembly.

END

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

Lost Communication with Automatic High Beam Sensor (B2432)

DESCRIPTION The DTC is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions in the LIN communication system. DTC No. DTC Detection Condition ...

HL AutoLeveling ECU Failure (B2420)

DESCRIPTION When the headlight leveling ECU assembly detects a malfunction in itself, this DTC is stored. DTC No. DTC Detecting Condition Trouble Area ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY (a) Engage the adjuster positioning hole with the guide and install the front shoulder belt anchor adjuster assembly with the 2 bolts. Torque: 42 N·m {428 ...

Customizable features
1. Vehicles with TFT type multi-information display: Some function settings can be changed by operating the multi-information display. 2. Settings that can be changed by your Toyota dealer Definition of symbols: O = Available, -- = Not available ...

Front Lower Suspension Arm(when Using The Engine Support Bridge)
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE FRONT FRAME ASSEMBLY for 1AR- ...