INITIALIZATION
HINT:
In vehicles equipped with the push-button start function, the starting function may not be operational after recharging or while jump-starting a discharged battery. This condition is most likely to occur if battery voltage drops below 9 V. The following procedure has been developed to address this condition.
1. INITIALIZATION PROCEDURE
(a) Confirm that the D/C CUT fuse is installed.
Text in Illustration
*1 |
DCC Fuse |
HINT:
If the D/C CUT fuse is not installed, install it at this time.
(b) Move the shift lever to P.
(c) Turn the engine switch off.
(d) Open the driver's door.
HINT:
Opening the driver's door will start an initialization process between the steering lock ECU (steering lock actuator assembly) and the engine room junction block.
(e) Depress the brake pedal.
(f) Press the engine switch.
Cellular Phone Inspection
PROCEDURE
1.
CHECK USAGE CONDITION
(a) Check that the vehicle and cellular phone meet the following conditions:
NOTICE:
If changing cellular phone settings, updating software, etc. is necessary, make
sure to obtain the per ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.
(e) Check the details of the DTC(s) (See pa ...
Window Defogger Wire
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK REAR WINDOW DEFOGGER SYSTEM OPERATION
(a) When the ignition switch is turned to ON and the rear window defogger switch
is pressed, check that the rear window defogger system operates.
2. I ...