Toyota Venza manuals

Toyota Venza: If your vehicle has to be stopped in an emergency

Toyota Venza Owners Manual / When trouble arises / Steps to take in an emergency / If your vehicle has to be stopped in an emergency

Only in an emergency, such as if it becomes impossible to stop the vehicle in the normal way, stop the vehicle using the following procedure:

Steadily step on the brake pedal
with both feet and firmly depress it.

Do not pump the brake pedal repeatedly as this will increase the effort required to slow the vehicle.

Shift the shift lever to N.


If the shift lever is shifted to N

After slowing down, stop the vehicle
in a safe place by the road.

Stop the engine.


If the shift lever cannot be shifted to N

Keep depressing the brake pedal
with both feet to reduce vehicle speed as much as possible.


Vehicles without a smart key system: Stop the engine by turning the engine switch to the “ACC” position.


Vehicles with a smart key system:

To stop the engine, press and hold the “ENGINE START STOP” switch for 2 consecutive seconds or more, or press it briefly 3 times or more in succession.

Stop the vehicle in a safe place
by the road.

 CAUTION

 - If the engine has to be turned off while driving

• Power assist for the brakes and steering wheel will be lost, making the brake pedal harder to depress and the steering wheel heavier to turn.

Decelerate as much as possible before turning off the engine.

• Vehicles without a smart key system: Never attempt to remove the key, as doing so will lock the steering wheel.

If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt, or snow. Stop the engine. Set the parking brake and shift the shift lever in “P”. Stop the eng ...

Vehicle specifications
Detailed vehicle information ...

Other materials about Toyota Venza:

All Door Entry Lock/Unlock Functions and Wireless Functions do not Operate
DESCRIPTION When the entry door lock and unlock functions and wireless door lock and unlock functions do not operate, radio wave interference, or a malfunction in the key or signal circuit between the door control receiver assembly and certification ECU ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT SEAT WIRE RH (for Front Passenger Side) (a) Engage each clamp and install the front seat wire RH. 2. INSTALL OCCUPANT CLASSIFICATION ECU (for Front Passenger Side) 3. INSTALL SEAT POSITION SENSOR 4. INSTALL SEA ...

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

© 2016-2022 Copyright www.tovenza.com

0.1478