CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
|
3. |
INSPECT BATTERY VOLTAGE |
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
4. |
CONNECT TECHSTREAM TO DLC3* |
|
5. |
CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* |
(a) Refer to DTC Check / Clear (See page ).
|
6. |
VISUAL INSPECTION |
|
7. |
SELECT CHECK MODE DIAGNOSIS* |
(a) Refer to Check Mode Procedure (See page
).
|
8. |
PROBLEM SYMPTOM CONFIRMATION |
(a) Refer to Road Test (See page ).
Result |
Proceed to |
---|---|
Symptom does not occur |
A |
Symptom occurs |
B |
B |
GO TO STEP 10 |
|
9. |
SYMPTOM SIMULATION |
(a) Refer to Symptom Simulation (See page
).
|
10. |
DTC CHECK* |
(a) Refer to DTC Check / Clear (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO STEP 18 |
|
11. |
BASIC INSPECTION |
(a) Refer to Park/Neutral Position Switch (See page ).
(b) Refer to Shift Lever Assembly (See page
).
NG |
GO TO STEP 21 |
|
12. |
MECHANICAL SYSTEM TESTS |
(a) Refer to Mechanical System Tests (See page ).
NG |
GO TO STEP 17 |
|
13. |
HYDRAULIC TEST |
(a) Refer to Hydraulic Test (See page ).
NG |
GO TO STEP 17 |
|
14. |
MANUAL SHIFTING TEST |
(a) Refer to Manual Shifting Test (See page
).
NG |
GO TO STEP 16 |
|
15. |
PROBLEM SYMPTOMS TABLE CHAPTER 1 |
(a) Refer to Problem Symptoms Table (See page ).
NG |
GO TO STEP 19 |
|
16. |
PROBLEM SYMPTOMS TABLE CHAPTER 2 |
(a) Refer to Problem Symptoms Table (See page ).
|
17. |
COMPONENT INSPECTION |
NEXT |
GO TO STEP 21 |
18. |
DTC CHART |
(a) Refer to Diagnostic Trouble Code Chart (See page ).
|
19. |
CIRCUIT INSPECTION |
|
20. |
IDENTIFICATION OF PROBLEM |
|
21. |
REPAIR OR REPLACE |
|
22. |
CONFIRMATION TEST |
NEXT |
END |
Trailer Tongue Weight
• A recommended tongue weight varies in accordance with the types of trailers
or towing as described below.
• To ensure the recommended values shown below, the trailer must be loaded by
referring to the following instructions.
• Tongue Weight The g ...
Voice Guidance does not Function
PROCEDURE
1.
CHECK VOICE GUIDANCE SETTING
(a) Check that the voice guidance setting is not off.
OK:
Voice guidance setting is not off.
NG
CHANGE THE VOICE GUIDANCE SETTING TO ON
...
System Description
SYSTEM DESCRIPTION
1. LIN COMMUNICATION SYSTEM DESCRIPTION
The LIN communication system is used for communication between the components
in the table below. If communication cannot be performed through LIN communication
because of an open in the communic ...