CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
3. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Result |
Proceed to |
---|---|
CAN DTC is not output |
A |
CAN DTC is output |
B |
B |
GO TO CAN COMMUNICATION SYSTEM |
|
4. |
CHECK FOR DTCs* |
(a) Check for DTCs (See page ).
(b) Clear the DTCs.
(c) Recheck for DTCs.
Result |
Proceed to |
---|---|
DTC does not reoccur |
A |
DTC does reoccur |
B |
B |
GO TO STEP 7 |
|
5. |
PROBLEM SYMPTOMS TABLE |
Result |
Proceed to |
---|---|
Fault not listed in problem symptoms table |
A |
Fault listed in problem symptoms table |
B |
B |
GO TO STEP 7 |
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU (See page ).
(b) Data List / Active Test (See page ).
|
7. |
REPAIR OR REPLACE |
|
8. |
CONFIRMATION TEST |
NEXT |
END |
Clock Display Circuit
DESCRIPTION
The accessory meter assembly uses this circuit to communicate with the combination
meter assembly via the direct line. The accessory meter assembly uses this circuit
to receive the drive monitor switch signals from the combination meter assemb ...
Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1) (P2195,P2196)
DESCRIPTION
HINT:
Although the DTC titles say oxygen sensor, these DTCs relate to the
air fuel ratio sensor.
Sensor 1 refers to the sensor mounted in front of the three-way catalytic
converter and located near the engine assembly.
...
Heated Oxygen Sensor
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 1 ENGINE UNDER COVER
2. REMOVE NO. 2 ENGINE UNDER COVER
3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
4. REMOVE HEATED OXYGEN SENSOR
(a) Using SST, remove the heat ...