CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
|
3. |
INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
4. |
CHECK CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally (See page ).
Result |
Proceed to |
---|---|
CAN communication system DTCs are not output |
A |
CAN communication system DTCs are output |
B |
B |
GO TO CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU) |
|
5. |
PROBLEM SYMPTOM CONFIRMATION |
|
6. |
CHECK DTC* |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTCs are output |
A |
DTCs are not output (Problem symptom does not occur) |
B |
DTCs are not output (Problem symptom occurs) |
C |
B |
GO TO STEP 8 |
C |
GO TO STEP 9 |
|
7. |
DIAGNOSTIC TROUBLE CODE CHART |
(a) Refer to Diagnostic Trouble Code Chart (See page ).
NEXT |
GO TO STEP 11 |
8. |
SYMPTOM SIMULATION |
(a) Refer to Symptom Simulation (See page
).
|
9. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page ).
Result |
Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table |
A |
Fault is listed in Problem Symptoms Table |
B |
B |
GO TO STEP 11 |
|
10. |
OVERALL ANALYSIS AND TROUBLESHOOTING |
(a) Operation Check (See page )
(b) Terminals of ECU (See page )
(c) Data List / Active Test (See page )
|
11. |
CIRCUIT INSPECTION* |
|
12. |
IDENTIFICATION OF PROBLEM |
|
13. |
REPAIR OR REPLACE |
|
14. |
CONFIRMATION TEST* |
NEXT |
END |
Inspection
INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
Ensure that fingers or articles of clothing do not get caught in moving parts
when performing this test.
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Check the LO operation.
(1) Conne ...
Precaution
PRECAUTION
1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following system after the cable is reconnected.
System Name
...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL GENERATOR ROTOR ASSEMBLY
(a) Place the generator drive end frame on the generator pulley.
(b) Install the generator rotor to the generator drive end frame.
...