Toyota Venza: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
- Use this procedure to troubleshoot the theft deterrent system.
- *: Use the Techstream.
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
.gif)
|
2. |
CUSTOMER PROBLEM ANALYSIS |
(a) Interview the customer to confirm the trouble (See page
.gif)
).
|
|
3. |
SYMPTOM SIMULATION |
|
|
4. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in Problem Symptoms Table |
A |
|
Fault is listed in Problem Symptoms Table |
B |
| B | .gif) |
GO TO STEP 6 |
|
|
5. |
PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM* |
(a) System Description (See page )
(b) Terminals of ECU (See page )
(c) Data List / Active Test (See page )
|
|
6. |
ADJUST, REPAIR OR REPLACE |
|
|
7. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
SYSTEM DIAGRAM
...
System Description
SYSTEM DESCRIPTION
1. OUTLINE OF THEFT DETERRENT SYSTEM
The theft deterrent system can be set by locking the doors using the
transmitter or key, or by opening and closing the doors (for d ...
Other materials about Toyota Venza:
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION LH
(a) Temporarily install a new front suspension member body mounting rear
cushion LH while confirming the installation direction.
NOTICE:
Position th ...
Vehicle Speed Sensor Malfunction (P0500)
DESCRIPTION
The vehicle speed sensors detect the wheel speed and send the appropriate signals
to the skid control ECU. The skid control ECU converts these wheel speed signals
into a 4-pulse signal and outputs it to the ECM via the combination meter assemb ...
Transfer Case Front Oil Seal(for Rh Side)
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. DRAIN TRANSFER OIL
(a) Remove the transfer drain plug and gasket to drain the transfer oil.
(b) Install a new gasket and the transfer drain plug.
Torque:
49 N·m {500 kgf ...
0.1201