Toyota Venza: How To Proceed With Troubleshooting

Toyota Venza Service Manual / Seat Belt / Seat Belt Warning System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use these procedure to troubleshoot the seat belt warning system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	CUSTOMER PROBLEM ANALYSIS

HINT:

In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
The following 5 items are important points in the problem analysis:

What	Vehicle, system name
When	Date, time, occurrence frequency
Where	Road conditions
Under what conditions?	Driving conditions, weather conditions
How did it happen?	Problem symptoms

3.	INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

4.	CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Result	Proceed to
CAN DTC is not output	A
CAN DTC is output	B

GO TO CAN COMMUNICATION SYSTEM

5.	CHECK FOR DTC (AIRBAG SYSTEM)*

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs.

Result	Proceed to
DTC is not output	A
DTC is output	B

GO TO AIRBAG SYSTEM

6.	CHECK FOR DTC (OCCUPANT CLASSIFICATION SYSTEM)*

(a) Clear the DTC (See page ).

(b) Recheck for DTCs.

Result	Proceed to
DTC is not output	A
DTC is output	B

GO TO OCCUPANT CLASSIFICATION SYSTEM

7.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page ).

Result	Proceed to
Fault is not listed in Problem Symptoms Table	A
Fault is listed in Problem Symptoms Table	B

GO TO STEP 9

8.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List / Active Test (See page ).

(b) Terminals of ECU (See page ).

9.	REPAIR OR REPLACE

10.	CONFIRMATION TEST

END

System Diagram

SYSTEM DIAGRAM Communication Table Sender Receiver Signal Communication Method Center airbag sensor assembly Combination mete ...

Customize Parameters

CUSTOMIZE PARAMETERS 1. CUSTOMIZE FUNCTION WITH TECHSTREAM NOTICE: Be sure to record the current settings before customizing. These buzzers should be ON for safe driving. Perform these ...

Other materials about Toyota Venza:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Starter Relay Circuit High (P0617)
MONITOR DESCRIPTION While the engine is being cranked, battery voltage is applied to terminal STA of the ECM. If the ECM detects the Starter Control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circu ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) 2. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) 3. REMOVE FRONT LICENSE PLATE BRACKET (a) Remove the 2 screws and ...