CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
(a) Interview the customer to confirm the trouble (See page ).
|
3. |
INSPECT BATTERY VOLTAGE |
(a) Measure the vehicle battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
4. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally (See page ).
Result |
Proceed to |
---|---|
CAN DTC is not output |
A |
CAN DTC is output |
B |
B |
GO TO CAN COMMUNICATION SYSTEM |
|
5. |
CHECK FOR DTC* |
(a) Check for DTCs and note any codes that are output (See page ).
(b) Clear the DTCs.
(c) Recheck for DTCs.
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
6. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page ).
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B |
GO TO STEP 8 |
|
7. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check (See page )
(b) Data List / Active Test (See page )
(c) Terminals of ECU (See page )
|
8. |
REPAIR OR REPLACE |
|
9. |
CONFIRMATION TEST |
NEXT |
END |
Automatic anti-glare function
Responding to the level of brightness of the headlights of vehicles behind, the
reflected light is automatically reduced.
Changing automatic anti-glare function mode ON/OFF
When the automatic anti-glare function is in ON mode, the indicator illuminates.
...
Precaution
PRECAUTION
1. NOTICE FOR INITIALIZATION
CAUTION:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following system after the cable is reconnected.
System Name
See Procedure
Back Do ...
Short in Driver Side Knee Airbag Squib Circuit (B1860/64-B1863/64)
DESCRIPTION
The driver side knee airbag squib circuit consists of the center airbag sensor
assembly and driver side knee airbag assembly.
The center airbag sensor assembly uses this circuit to deploy the airbag when
deployment conditions are met.
These ...