CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
(a) Inspect the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
3. |
CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the LIN communication system is functioning normally.
Result |
Proceed to |
---|---|
LIN DTC is not output |
A |
LIN DTC is output |
B ( ) |
B |
GO TO LIN COMMUNICATION SYSTEM |
|
4. |
CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Result |
Proceed to |
---|---|
CAN DTC is not output |
A |
CAN DTC is output |
B ( ) |
B |
GO TO CAN COMMUNICATION SYSTEM |
|
5. |
CHECK FOR DTC* |
(a) Check for DTCs and note any code that is output.
(b) Clear the DTCs.
(c) Recheck for DTCs. Based on the DTCs output above, try to force the A/C system to output DTCs by simulating the conditions indicated by the DTC.
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO STEP 8 |
|
6. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page ).
Result |
Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table |
A |
Fault is listed in Problem Symptoms Table |
B |
B |
GO TO STEP 8 |
|
7. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Panel diagnosis (indicator check) (See page )
(b) Panel diagnosis (sensor check) (See page )
(c) Panel diagnosis (actuator check) (See page )
(d) Data List / Active Test (See page )
(e) Terminals of ECU (See page )
(f) On-vehicle Inspection
(g) Inspection
|
8. |
ADJUST, REPAIR OR REPLACE |
NEXT |
END |
Oil Pressure Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Disconnect the oil pressure switch connector.
(b) Start the engine.
(c) Measure the resistance according to the valu ...
Operation Check
OPERATION CHECK
1. SMART KEY SYSTEM OPERATION INSPECTION
(a) Check the entry unlock function.
(1) Use the wireless lock operation to lock the doors. With the key outside the
vehicle, touch a front door outside handle assembly (touch sensor) and check that ...
Display does not Dim when Light Control Switch is Turned ON
PROCEDURE
1.
CHECK IMAGE QUALITY SETTING
(a) Turn the light control switch to the tail or head position.
(b) Check that the daytime screen setting on the display adjustment screen is
set to on.
Result
...