Toyota Venza manuals

Toyota Venza: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the power window control system.
  • *: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP


NEXT

2.

CUSTOMER PROBLEM ANALYSIS

  • In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
  • Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
  • The following 5 items are important points in the problem analysis:

    What

    Vehicle model, system name

    When

    Date, time, occurrence frequency

    Where

    Road conditions

    Under what conditions?

    Driving conditions, weather conditions

    How did it happen?

    Problem symptoms


NEXT

3.

PRE-CHECK

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

(b) Check the fuses and relays.

(c) Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.


NEXT

4.

INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the LIN communication system is functioning normally (See page ).


Result

Proceed to

No DTCs output

A

DTCs output

B


B

GO TO LIN COMMUNICATION SYSTEM


A

5.

CHECK FOR DTC*

(a) Check for DTCs and note any codes that are output (See page ).


(b) Clear the DTCs.

(c) Recheck for DTCs.

Result

Proceed to

No DTCs output

A

DTCs output

B


B

GO TO DIAGNOSTIC TROUBLE CODE CHART


A

6.

PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page ).


Result

Proceed to

Fault is not listed in problem symptoms table

A

Fault is listed in problem symptoms table

B


B

GO TO STEP 8


A

7.

OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check (See page )


(b) Data List / Active Test (See page )


(c) Terminals of ECU (See page )



NEXT

8.

REPAIR OR REPLACE


NEXT

9.

INITIALIZE POWER WINDOW CONTROL SYSTEM

(a) If any of the door window regulator sub-assemblies, power window regulator motor assemblies, door glass or door glass runs have been removed and reinstalled, perform "Initialize Power Window Control System" for the applicable door glass (See page ).



NEXT

10.

CONFIRMATION TEST


NEXT

END

System Diagram
SYSTEM DIAGRAM Communication Table Transmitting ECU Receiving ECU Signal Communication Method Power window regulator master switch ass ...

System Description
SYSTEM DESCRIPTION 1. POWER WINDOW CONTROL SYSTEM DESCRIPTION (a) The power window control system controls the power window operation using the power window regulator motors. The main controls of ...

Other materials about Toyota Venza:

Cleaning and protecting the vehicle exterior
Perform the following to protect the vehicle and maintain it in prime condition. • Working from top to bottom, liberally apply water to the vehicle body, wheel wells and underside of the vehicle to remove any dirt and dust. Wash the vehicle body using a ...

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Short in Front Passenger Side Squib Circuit (B1805/52-B1808/52)
DESCRIPTION The front passenger side squib circuit consists of the center airbag sensor assembly and front passenger airbag assembly. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs ...

© 2016-2024 Copyright www.tovenza.com

0.1261