CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
(a) Interview the customer to confirm the problem.
HINT:
It is important to collect as much specific information as possible from the customer to allow for a quick repair.
|
3. |
ADJUST TIRE PRESSURE* |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
(e) Read the "ID Tire Inflation Pressure" values.
(f) Set all tire pressures to the specified value(s) (See page ).
(g) Check the Data List (See page ).
HINT:
Result |
Proceed to |
---|---|
Tire pressure warning light goes off |
A |
Tire pressure warning light remains on |
B |
B |
GO TO STEP 9 |
|
4. |
CHECK FOR DTC |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is output |
A |
DTC is not output |
B |
B |
GO TO STEP 6 |
|
5. |
DTC CHART |
(a) Refer to Diagnostic Trouble Code Chart (See page ).
NEXT |
GO TO STEP 7 |
6. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page ).
|
7. |
CIRCUIT INSPECTION* |
(a) Refer to Electronic Circuit Inspection Procedure (See page ).
|
8. |
REPAIR OR REPLACE |
(a) Repair or replace parts based on the diagnosis result.
|
9. |
CONFIRMATION TEST* |
(a) Check the Data List to confirm that the tire inflation pressures have been received (See page ).
NEXT |
END |
Installation
INSTALLATION
PROCEDURE
1. INSTALL PARKING BRAKE PEDAL ASSEMBLY
(a) Install the parking brake pedal assembly with the 3 nuts.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
(b) Connect t ...
Customize Parameters
CUSTOMIZE PARAMETERS
1. CUSTOMIZE LIGHTING SYSTEM (EXT)
HINT:
The following items can be customized.
NOTICE:
When the customer requests a change in a function, first make sure that
the function can be customized.
Be sure to make a note of ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL MANUAL VALVE
(a) Coat the manual valve with ATF and install it to the transmission valve body
assembly.
2. SUPPORT ENGINE ASSEMBLY
3. INSTALL TRANSMISSION VALVE BODY ASSEMBLY
(a) Coat the O-ring of the transmission ...