Toyota Venza: How To Proceed With Troubleshooting

Toyota Venza Service Manual / Tire / Wheel / Tire And Wheel System / How To Proceed With Troubleshooting

PROCEDURE

1.	CHECK TIRE AND WHEEL SYSTEM

DIAGNOSIS OF IRREGULAR TIRE WEAR

GO TO STEP 11

DIAGNOSIS OF TIRE VIBRATION

2.	TIGHTEN WHEEL NUTS

3.	INSPECT TIRES

(See page )

GO TO STEP 5

4.	REPAIR OR REPLACE TIRE(S)

GO TO STEP 5

5.	INSPECT AND/OR ADJUST WHEEL BALANCE

(See page )

6.	INSPECT FRONT AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT

(See page )

GO TO STEP 8

7.	REPAIR FRONT AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT

(See page )

GO TO STEP 8

8.	INSPECT REAR AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT

(a) for 2WD (See page )

(b) for AWD (See page )

GO TO STEP 10

9.	REPAIR REAR AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT

(a) for 2WD (See page )

(b) for AWD (See page )

10.	PERFORM ROAD TEST

RETURN VEHICLE TO CUSTOMER

11.	INSPECT TIRES

(See page )

12.	REPAIR OR REPLACE TIRE(S)

13.	INSPECT AND/OR ADJUST FRONT WHEEL ALIGNMENT

(See page )

14.	INSPECT AND/OR ADJUST REAR WHEEL ALIGNMENT

(See page )

15.	PERFORM ROAD TEST

RETURN VEHICLE TO CUSTOMER

Inspection

INSPECTION PROCEDURE 1. INSPECT TIRES (a) Inspect the tires for wear and proper inflation pressure. Cold Tire Inflation Pressure: Tire Size Front kPa (kgf/cm2, psi) ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POWER MANAGEMENT CONTROL ECU (a) Disconnect the D42 and D43 connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. Tester Connection Wiring Color Termi ...

TRAC OFF Indicator Light Remains ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls. If TRAC control is turned off, ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...