Toyota Venza: How To Proceed With Troubleshooting

Toyota Venza Service Manual / Cruise Control / Cruise Control System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the cruise control system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	INSPECT BATTERY VOLTAGE

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

3.	CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Result	Proceed to
CAN DTC is not output	A
CAN DTC is output	B

GO TO CAN COMMUNICATION SYSTEM (DTC CHART)

4.	CHECK FOR DTCs*

Refer to DTC Check / Clear (See page ).

(a) Check for DTCs and note any codes that are output.

(b) Clear the DTCs.

Result	Proceed to
DTC does not reoccur	A
DTC reoccurs	B

GO TO DTC CHART

5.	PROBLEM SYMPTOMS TABLE

Refer to Problem Symptoms Table (See page
).

Result	Proceed to
Fault is not listed in Problem Symptoms Table	A
Fault is listed in Problem Symptoms Table	B

GO TO STEP 7

6.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Terminals of ECM (See page ).

(b) Data List / Active Test (See page ).

7.	ADJUST, REPAIR OR REPLACE

8.	CONFIRMATION TEST

END

System Description

SYSTEM DESCRIPTION 1. CRUISE CONTROL SYSTEM This system is controlled by the ECM, and is activated by the throttle position sensor and motor. The ECM controls the following functions: ON-OFF, - SE ...

Road Test

ROAD TEST 1. PROBLEM SYMPTOM CONFIRMATION (a) Inspect the SET function. Text in Illustration *1 ON/OFF *2 - SET (1) Turn the cruise con ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and the LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. REMOVE REAR AXLE SHAFT NUT (for AWD) NOTICE: Perform th ...

Starter Relay Circuit High (P0617)
MONITOR DESCRIPTION While the engine is being cranked, battery voltage is applied to terminal STA of the ECM. If the ECM detects the Starter Control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circu ...

Terminals Of Ecu
TERMINALS OF ECU 1. POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (a) Disconnect the I6 power window regulator master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the val ...