DESCRIPTION
When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (driver side junction block assembly) transmits a signal to cause the horn to sound at intervals of 0.4 seconds.
WIRING DIAGRAM
PROCEDURE
1. |
INSPECT HORNS |
(a) Press the horn switch and check if the horns sound.
Result |
Proceed to |
---|---|
Horns sound |
A |
Horns do not sound |
B |
B |
GO TO HORN SYSTEM |
|
2. |
PERFORM ACTIVE TEST USING TECHSTREAM |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Select the item below in the Active Test and then check that the horns operate.
Main Body
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
---|---|---|---|
Vehicle Horn |
Vehicle horns |
ON / OFF |
- |
OK:
The vehicle horns sound and stop correctly when operated through the Techstream.
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
NG |
REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) |
Steering Knuckle
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE FRONT AXLE ASSEMBLY
HINT:
...
Daytime Running Light Relay Circuit
DESCRIPTION
The main body ECU (driver side junction block assembly) controls the daytime
running lights.
WIRING DIAGRAM
1. for Halogen Headlight
2. for HID Headlight
PROCEDURE
1.
PERFORM ACTIVE TEST USING TECHSTREAM
...
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...