Toyota Venza: Horn

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: When installing the mouldings, heat the vehicle body and mouldings using a heat light. Heating Temperature Item Temperature ...

Horn

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT LOW PITCHED HORN ASSEMBLY (a) Apply battery voltage and check the operation of the low pitched ...

Other materials about Toyota Venza:

Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2) (P0778)
DESCRIPTION Changing from 1st to 6th is performed by the TCM turning shift solenoid valves SL1, SL2, SL3, SL4 and SL on and off. If an open or short circuit occurs in any of the shift solenoid valves, the TCM controls the remaining normal shift solenoid ...

Removal
REMOVAL PROCEDURE 1. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 1AR-FE) 2. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 2GR-FE) 3. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 1AR-FE) 4. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2GR-FE) 5. REMOVE PROPELLER ...

Electrical Key Oscillator(for Rear Side)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE REAR BUMPER PLATE LH 2. REMOVE REAR BUMPER PLATE RH 3. REMOVE REAR BUMPER ASSEMBLY 4. REMOVE ELECTRICAL KEY ANTENNA (a) Disconnect the connector. ...