Toyota Venza: Height Control Sensor Data Out of Range When Initializing (B2452)

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Height Control Sensor Data Out of Range When Initializing (B2452)

DESCRIPTION

The headlight leveling ECU assembly stores this DTC if the sensor value received from the height control sensor is out of range when performing initialization of the headlight leveling ECU assembly; for example, the vehicle is not level or being jacked up.

DTC No.	DTC Detecting Condition	Trouble Area
B2452	Vehicle condition not specified when initializing	Vehicle condition when initializing Headlight leveling ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

If the headlight leveling ECU assembly has been replaced, initialization of the headlight leveling ECU assembly is necessary (See page ).

PROCEDURE

1.	PERFORM INITIALIZATION

(a) Perform initialization of the headlight leveling ECU assembly (See page ).

HINT:

Before initializing the headlight leveling ECU assembly, make sure that the vehicle condition is proper for initialization.
Be sure to perform initialization as instructed.

2.	RECHECK FOR DTC

(a) Using the Techstream, recheck for DTCs.

Result	Proceed to
DTC B2452 is not output.	A
DTC B2452 is output.	B

HINT:

If the headlight leveling ECU assembly stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the headlight leveling ECU assembly.

END

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

Vehicle Speed Sensor Malfunction (B2415)

DESCRIPTION The AFS ECU (headlight swivel ECU assembly) receives signals indicating the front right wheel speed from the skid control ECU using CAN communication. DTC No. DTC ...

Variation Error (B2453)

DESCRIPTION This DTC is stored if the headlight leveling ECU assembly for another destination is installed on the vehicle. DTC No. DTC Detecting Condition Trouble ...

Other materials about Toyota Venza:

Engine Immobiliser System Malfunction (B2799)
DESCRIPTION This DTC is stored when one of the following occurs: 1) the ECM detects an error in its own communication with the certification ECU (smart key ECU assembly); 2) the ECM detects an error in the communication lines; or 3) the ECU communication ...

Back Door Closer Switch Malfunction (B2251)
DESCRIPTION The power back door ECU (power back door motor unit)*1 or back door closer ECU (multiplex network door ECU)*2 receives signals from the latch switch, sector switch and back door courtesy switch, which are built into the back door lock. Based o ...

Registration
REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION It is necessary to register the transmitter IDs in the tire pressure warning ECU when replacing a tire pressure warning valve and transmitter and/or a tire pressure warning ECU. Prepare all tra ...