DESCRIPTION
These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B1551 |
When any of the following conditions is met:
|
Radio and display receiver assembly |
B158D |
The internal video signal of the radio and display receiver assembly is interrupted |
|
B15A0 |
When either of the following conditions is met:
|
|
B15B0 |
Picture circuit (TFT unit) malfunction |
|
B15B3 |
When any of the following conditions is met:
|
|
B15B4 |
When any of the following conditions is met:
|
|
B15B7 |
"Bluetooth" module malfunction |
PROCEDURE
1. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs and check that no DTCs are output.
OK:
No DTCs are output.
OK |
USE SIMULATION METHOD TO CHECK |
NG |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
Vehicle identification
- Vehicle identification number
The vehicle identification number (VIN) is the legal identifier for your vehicle.
This is the primary identification number for your Toyota. It is used in registering
the ownership of your vehicle.
This number is s ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL DOOR SIDE AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) C ...
Stop Light Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE STOP LIGHT SWITCH ASSEMBLY
(a) Disconnect the connector.
(b) Turn the stop light switch assembly countercl ...