Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL TANK CAP ASSEMBLY
(a) Visually check that the fuel tank cap assembly and gasket are not deformed or damaged. Text in Illustration
If the result is not as specified, replace the fuel tank cap assembly. |
|
(b) Confirm that ID mark S is printed on the fuel tank cap assembly. Text in Illustration
CAUTION: Make sure to use a fuel tank cap assembly that has the same ID mark, or a malfunction may occur in the fuel system. |
|
Bleeding
BLEEDING
CAUTION / NOTICE / HINT
NOTICE:
Do not allow brake fluid to adhere to any painted surface such as the
vehicle body. If brake fluid leaks onto any painted surface, immediately
wash it off.
Before bleeding the brake system, confir ...
Runnable Signal Malfunction (B2286,P0335)
DESCRIPTION
The power management control ECU receives an engine speed signal and information
that indicates whether the engine is running or not. It receives the engine speed
signal from the ECM via a direct line, and the information about whether the eng ...
Catalyst System Efficiency Below Threshold (Bank 1) (P0420)
MONITOR DESCRIPTION
The ECM uses sensors mounted in front of and behind the Three-Way Catalytic Converter
(TWC) to monitor its efficiency.
The first sensor, the air fuel ratio sensor, sends pre-catalyst information to
the ECM. The second sensor, the heat ...