Toyota Venza: Front Wiper Rubber
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE FRONT WIPER BLADE
|
(a) Remove the holder of the front wiper blade. |
|
(b) Remove the front wiper blade from the front wiper arm as shown in the illustration.
NOTICE:
Do not lower the front wiper arm with the front wiper blade removed. The arm tip could damage the windshield surface.
2. REMOVE WIPER RUBBER
|
(a) Remove the wiper rubber with the wiper rubber backing plates from the front wiper blade. |
|
|
(b) Remove the wiper rubber from the 2 wiper rubber backing plates. |
|
3. INSTALL WIPER RUBBER
|
(a) Install the 2 wiper rubber backing plates to the wiper rubber. Text in Illustration
NOTICE:
|
|
|
(b) Install the wiper rubber and the 2 wiper rubber backing plates to the front wiper blade with the tip of the rubber (curved end) facing the axis of the wiper arm. HINT: Firmly push the wiper rubber into the wiper blade to securely engage them. |
|
4. INSTALL FRONT WIPER BLADE
|
(a) Install the front wiper blade as shown in the illustration. |
|
(b) Install the holder of the front wiper blade.
Installation
INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Using a T30 "TORX" socket wrench, install the windshield wiper motor
assembly with the 2 bolts.
Tor ...
Rear Wiper Motor
...
Other materials about Toyota Venza:
Input / Turbine Speed Sensor Circuit Malfunction (P0715,P0717)
DESCRIPTION
This sensor detects the rotation speed of the turbine which shows the input revolution
(speed) of the transaxle. By comparing the input turbine speed signal (NT) with
the counter gear speed sensor signal (NC), the TCM detects the shift timing ...
Definition Of Terms
DEFINITION OF TERMS
Term
Definition
Monitor description
Description of what the TCM monitors and how it detects malfunctions
(monitoring purpose and its details).
Related DTCs
D ...
Noise Occurs
PROCEDURE
1.
CHECK NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear
left or right).
OK:
The location of the noise source can be determined.
NG
GO TO STEP 3
...
0.1759