Toyota Venza: Front Lower Suspension Arm(when Using The Engine Support Bridge)

Toyota Venza Service Manual / Front Suspension / Front Lower Suspension Arm(when Using The Engine Support Bridge)

Components

COMPONENTS

ILLUSTRATION

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT FRAME ASSEMBLY

for 1AR-FE: (See page )

for 2GR-FE: (See page )

2. REMOVE FRONT LOWER SUSPENSION ARM

(a) Remove the 3 bolts, nut and front lower suspension arm from the front frame assembly.

(b) Remove the front lower arm bushing stopper from the front lower suspension arm.

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.

PROCEDURE

1. INSTALL FRONT LOWER SUSPENSION ARM

(a) Install the front lower arm bushing stopper to the front lower suspension arm.

(b) Temporarily tighten the front lower suspension arm to the front frame assembly with the 3 bolts and nut.

Torque:

Bolt 1, 2 :

200 N·m {2039 kgf·cm, 147 ft·lbf}

Bolt 3 :

135 N·m {1377 kgf·cm, 100 ft·lbf}

HINT:

Start installing the bolts from the front of the vehicle.

2. INSTALL FRONT FRAME ASSEMBLY

for 1AR-FE: (See page )

for 2GR-FE: (See page )

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT LOWER SUSPE ...

Other materials about Toyota Venza:

Back Door Closer Operation Malfunction (B2250)
DESCRIPTION The power back door ECU (power back door motor unit)*1 or back door closer ECU (multiplex network door ECU)*2 receives signals from the latch switch, sector switch and back door courtesy switch, which are built into the back door lock. Based o ...

Power Window Motor Malfunction (B2311)
DESCRIPTION The power window regulator motor is operated by the power window regulator master switch assembly or power window regulator switch assembly. The power window regulator motor assembly has motor, regulator and ECU functions. This DTC is output ...

Solar Sensor
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT SOLAR SENSOR (a) Disconnect the solar sensor connector. (b) Measure the voltage accordin ...

Toyota Venza: Front Lower Suspension Arm(when Using The Engine Support Bridge)

Installation

Front Shock Absorber

Other materials about Toyota Venza: