Toyota Venza manuals

Toyota Venza: Front Door Speaker

Components

COMPONENTS

ILLUSTRATION


Removal

REMOVAL

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ).


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


5. REMOVE COURTESY LIGHT ASSEMBLY


6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

(a) Disconnect the connector.


(b) Remove the 4 bolts and the front No. 1 speaker assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY

(a) With the speaker installed, check that there is no looseness or other abnormalities.

(b) Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.

(c) Measure the resistance of the speaker.

Standard Resistance:

for 6 Speakers:

Tester Connection

Condition

Specified Condition

1 - 2

Always

3.2 to 4.8 Ω

for 13 Speakers:

Tester Connection

Condition

Specified Condition

1 - 2

Always

1.65 to 2.15 Ω

If the result is not as specified, replace the speaker.

Text in Illustration

*a

Component without harness connected

(Front No. 1 Speaker Assembly)


Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

(a) Install the front No. 1 speaker assembly with the 4 bolts.


(b) Connect the connector.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


3. INSTALL COURTESY LIGHT ASSEMBLY


4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


Radio Receiver Power Source Circuit
DESCRIPTION This is the power source circuit to operate the radio and display receiver assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this sy ...

Instrument Panel Speaker
...

Other materials about Toyota Venza:

Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF REAR SHOCK ABSORBER (a) Fully extend the shock absorber piston rod. (b) Using a drill, make a hole in area B shown in the illustration to discharge the gas inside. ...

Customize Parameters
CUSTOMIZE PARAMETERS HINT: The following items can be customized. NOTICE: After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations. Be sure to record the current se ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL GENERATOR ROTOR ASSEMBLY (a) Place the generator drive end frame on the generator pulley. (b) Install the generator rotor to the generator drive end frame. ...

© 2016-2024 Copyright www.tovenza.com

0.1282