DESCRIPTION
The front airbag sensor LH circuit consists of the center airbag sensor assembly and front airbag sensor LH.
The front airbag sensor LH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1615/14 is stored when a malfunction is detected in the front airbag sensor LH.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B1615/14 |
|
|
WIRING DIAGRAM
PROCEDURE
1. |
CHECK FRONT AIRBAG SENSOR LH |
(a) Turn the ignition switch off. |
|
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Interchange the front airbag sensor RH with LH and connect the connectors.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the ignition switch to ON, and wait for at least 60 seconds.
(f) Clear the DTCs stored in memory (See page ).
(g) Turn the ignition switch off.
(h) Turn the ignition switch to ON, and wait for at least 60 seconds.
(i) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTCs B1610/13 and B1615/14 are not output. |
A |
DTC B1615/14 is output. |
B |
DTC B1610/13 is output. |
C |
*1 |
Front Airbag Sensor RH |
*2 |
Center Airbag Sensor Assembly |
HINT:
Codes other than DTCs B1610/13 and B1615/14 may be output at this time, but they are not related to this check.
A |
USE SIMULATION METHOD TO CHECK |
B |
REPLACE CENTER AIRBAG SENSOR ASSEMBLY |
C |
REPLACE FRONT AIRBAG SENSOR LH |
Indicators and warning lights
The indicator and warning lights on the instrument cluster and center panel
inform the driver of the status of the vehicle’s various systems.
For the purpose of explanation, the following illustration displays all indicators
and warning lights illuminat ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Engage the adjuster positioning hole with the guide and install the
front shoulder belt anchor adjuster assembly with the 2 bolts.
Torque:
42 N·m {428 ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE POSITION INDICATOR HOUSING SUB-ASSEMBLY
(a) Remove the shift lever cap from the position indicator housing sub-assembly.
(b) Disengage the 4 claws and remove the position indicator housing sub-assembly.
...