Toyota Venza manuals

Toyota Venza: Freeze Frame Data

FREEZE FRAME DATA

1. CHECK FREEZE FRAME DATA

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

(e) Select a DTC to display its freeze frame data.

2. LIST OF FREEZE FRAME DATA

(a) Refer to Data List / Active Test (See page ).


Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (CHECK USING TECHSTREAM) (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when dec ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SEAT FRAME WITH ADJUSTER LH (a) Check operation of the seat frame (slide motor). (1) w/ Memory: Check if the seat frame moves smoothly when the battery is connected to the slide motor connector termin ...

Follow the correction procedures. (smart key system)
After taking the specified steps to correct the suspected problem, check that the warning light turns off.  - If the malfunction indicator lamp comes on while driving First check the following: • Is the fuel empty? If it is, fill the fuel tan ...

Stop Light Control Relay Malfunction (C1380/64)
DESCRIPTION Upon receiving the hill-start assist control operating signal from the skid control ECU, the relay contact turns on and the stop light comes on. DTC Code DTC Detection Condition Trouble Area C13 ...

© 2016-2022 Copyright www.tovenza.com

0.1701