Toyota Venza manuals

Toyota Venza: Fog light switch

The fog lights improve visibility in difficult driving conditions, such as in rain or fog. The fog lights can be used when the headlights are on low beam.

Type A


1. Off


2. On


Type B


1. Off


2. On


Wiper intervals can be adjusted for intermittent operation (when or
is selected).


Type A


1. Off


2. Intermittent wiper operation


3. Low speed wiper operation


4. High speed wiper operation


5. Temporary operation



6. Increases the intermittent windshield wiper frequency

7. Decreases the intermittent windshield wiper frequency


8. Wash/wipe operation

Wipers operate automatically.

Type B


1. Off


2. Intermittent wiper operation


3. Low speed wiper operation


4. High speed wiper operation


5. Temporary operation



6. Increases the intermittent windshield wiper frequency

7. Decreases the intermittent windshield wiper frequency


8. Wash/wipe operation

Wipers operate automatically.

 - The windshield wiper and washer can be operated when

Vehicles with smart key system The “ENGINE START STOP” switch is in IGNITION ON mode.

Vehicles without smart key system The engine switch is in the “ON” position.

 - If no windshield washer fluid sprays

Check that the washer nozzles are not blocked if there is washer fluid in the windshield washer fluid reservoir.

CAUTION

 - Caution regarding the use of washer fluid

When it is cold, do not use the washer fluid until the windshield becomes warm. The fluid may freeze on the windshield and cause low visibility. This may lead to an accident, resulting in death or serious injury.

NOTICE
 - When the windshield is dry

Do not use the wipers, as they may damage the windshield.

- When there is no washer fluid spray from the nozzle

Damage to the washer fluid pump may be caused if the lever is pulled toward you and held continually.

- When a nozzle becomes blocked

Do not try to clear it with a pin or other object. The nozzle will be damaged.

Automatic High Beam
The Automatic High Beam uses an in-vehicle camera sensor to assess the brightness of streetlights, the lights of oncoming and preceding vehicles, etc., and automatically turns high beam on or off ...

Rear window wiper and washer
Type A 1. Off 2. Intermittent window wiper operation 3. Normal window wiper operation 4. Washer/wiper dual operation 5. Washer/wiper dual operation Type B 1. Off 2. Intermittent win ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL TRANSFER DRIVEN PINION REAR BEARING (a) Using SST and a press, press the transfer driven pinion rear bearing (outer race) to the case. SST: 09950-60010 09951-00620 SST: 09950-70010 09951-07150 NO ...

Rear Light Assembly
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR LIGHT ASSEMBLY (a) Disconnect the connector from the rear light assembly. (b) Measu ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

© 2016-2024 Copyright www.tovenza.com

0.1177