Toyota Venza: Fail-safe Chart

Toyota Venza Service Manual / Power Assist Systems / Power Steering System / Fail-safe Chart

FAIL-SAFE CHART

If a problem occurs in the power steering system, the power steering assist will be stopped or the amount of power assist will be decreased to protect the system.

Power Steering System

Malfunction	Fail-safe Operation
Torque sensor (steering column assembly) malfunction Power steering motor (steering column assembly) malfunction Power steering ECU assembly malfunction	Power steering assist stops or assist amount is limited
Vehicle speed signal malfunction Skid control ECU (brake actuator assembly) malfunction History of power steering ECU assembly overheating History of decrease in battery voltage (not malfunction)	Power steering assist is temporarily limited

HINT:

The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or being driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal when the steering wheel is not turned for approximately 10 minutes with the engine idling.
If the battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns to normal when the battery voltage recovers.

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL UNLOCK WARNING SWITCH (a) Engage the 2 claws and install the unlock warning switch to the steering column upper bracket. (b) Extract the key. (c) Co ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new oil seal. NOTICE: Do not allow foreign matter to contact the lip of the oil seal. Do not allow MP grease to contact the dust seal. ...

Vsc Off Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE FR ...